M86 Security M86 User Manual page 182

WF G A
LOBAL DMINISTRATOR
154
S C 1: S
ECTION HAPTER
For the Target mode setting:
1. In the Mode frame, click "Target" to display the Target
mode view:
Fig. 2:1-48 Setup window, Target mode
In the IP to Send frame, the LAN1 and LAN2 IP
addresses set up in the LAN Settings window on this
server display in the IP to Send pull-down menu.
2. In the Source IP frame, enter the Source IP address to
use for sending profile/library setting changes to this
server being configured.
NOTE: If a source server is set up with a NAT device, the NAT IP
address must be used instead of the source server's own IP
address.
3. Click Test Source to open an alert box that provides the
server mode status for the IP address you entered.
4. Click OK to close the alert box, and make any adjust-
ments, if necessary.
5. After validating the source IP address, click Change
Source to display this IP address in the Current Source
IP display field.
YSTEM SCREEN
M86 S U G
ECURITY SER UIDE