Cisco Ip Phone 8800 Series Administration Guide For Cisco Unified Communications Manager - Cisco 8800 Series Administration Manual

The Load Server is configured from the Enterprise Phone Configuration window. From Cisco Unified
Communications Manager Administration, choose Device > Phone >Enterprise Phone Configuration.
Set Up IPv4
The following table describes the IPv4 Setup menu options.
Table 12: IPv4 Setup Menu Options
Option
DHCP Enabled
IP Address
Subnet Mask
Default Router
DNS Server 1
DNS Server 2
DNS Server 3
Alternate TFTP
Description
Indicates whether the phone has DHCP enabled or
disabled.
When DHCP is enabled, the DHCP server assigns
the phone an IP address. When DHCP is disabled,
the administrator must manually assign an IP
address to the phone.
For more information, see
DHCP, on page 64 and
DHCP, on page 65.
Internet Protocol (IP) address of the phone.
If you assign an IP address with this option, you
must also assign a subnet mask and default router.
See the Subnet Mask and Default Router options
in this table.
Subnet mask used by the phone.
Default router used by the phone.
Primary Domain Name System (DNS) server (DNS
Server 1) and optional backup DNS servers (DNS
Server 2 and 3) that the phone uses.
Indicates whether the phone is using an alternate
TFTP server.

Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager

To change
See
on page
Set Up Phone to Use
Set Up Phone to Not Use
See
page
See
page
See
on page
See
page
See
on page
Configure Network Settings
Set DHCP Enabled Field,
62.
Set IP Address Field, on
63.
Set Subnet Mask Field, on
63.
Set Default Router Field,
63.
Set DNS Server Fields, on
63.
Set Alternate TFTP Field,
64.
53