Cisco Ip Phone 8800 Series Administration Guide For Cisco Unified Communications Manager - Cisco 8800 Series Administration Manual

Cisco IP Phone Status
Item
Frequency
Current channel
Last RSSI
Beacon interval
Capability
Basic rates
Optional rates
Supported VHT(rx)
rates
Supported VHT(tx)
rates
Supported HT MCS
DTIM period
Country code
Channels
Power constraint
Power limit
Channel utilization
Station count
Admission capacity

Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager

268
Description
The latest frequency where this AP was observed.
The latest channel where this AP was observed.
The latest RSSI in which this AP was observed.
Number of time units between beacons. A time unit is 1.024 ms.
This field contains a number of subfields that are used to indicate requested or
advertised optional capabilities.
Data rates that the AP requires and the AP at which the station must be capable of
operating.
Data rates that the AP supports and the AP that are optional for the station to operate
at.
VHT Supported RX MCS Set received from AP.
VHT Supported TX MCS Set received from AP.
HT Supported MCS Set received from AP.
Every nth beacon is a dtime period. After each DTIM beacon, the AP sends any
broadcast or multicast packets that are queued for power-save devices.
A two-digit country code. Country information might not be display if the country
information element (IE) is not present in the beacon.
A list of supported channels (from the country IE).
The amount of power by which the maximum transmit power should be reduced
from the regulatory domain limit.
Maximum transmit power in dBm that is permitted for that channel.
The percentage of time, normalized to 255, in which the AP sensed the medium
was busy, as indicated by the physical or virtual carrier sense (CS) mechanism.
The total number of STAs currently associated with this AP.
An unsigned integer that specifies the remaining amount of medium time that is
available through explicit admission control, in units of 32 microseconds per second.
If the value is 0, the AP does not support this information element and the capacity
is unknown.