Cisco 8800 Series Administration Manual page 21

New and Changed Information
Revision
Set WLAN Authentication Attempts is supported.
Enable WLAN Prompt Mode is supported.
Customize Dial Tone is supported.
Display Network Info Screen is supported.
New Information for Firmware Release 11.0
All new features have been added to
All references into Cisco Unified Communications Manager documentation have been updated to support all
Cisco Unified Communications Manager releases.
Table 3: Cisco IP Phone 8800 Administration Guide Revisions for Firmware Release 11.0
Revision
Updated for clarification and to address deficiencies
Updated for improved Sectional phone debug option
support
Updated for improved EAP-TLS + SCEP,
PEAP-GTC, and X.509 digital certificates support
Telephone Features, on page
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
New Information for Firmware Release 11.0
Updated Section
Set WLAN Authentication Attempts, on page 46
Enable WLAN Prompt Mode, on page 47
Customize Dial Tone, on page 167
Display Network Information Screen, on page 260
170.
Updated Section
• VPN Configuration, on page 240
• Set Up IPv6, on page 56
• Key Expansion Module Power Information, on
page 94
• Set Up Energy Efficient Ethernet for Switch
and PC Port, on page 217
• Video Transmit Resolution Setup, on page 245
• Enhanced Survivable Remote Site Telephony,
on page 77
• Control Debug Information from Cisco Unified
Communications Manager, on page
• WLAN Security, on page
• Set Up Authentication Mode, on page 144
• Wireless Security Credentials, on page 144
305.
141.
3