Cisco Ip Phone 8800 Series Administration Guide For Cisco Unified Communications Manager - Cisco 8800 Series Administration Manual

Enable Intelligent Proximity
Feature
Speed Dial
Survivable Remote Site Telephony (SRST)
Transfer
Uniform Resource Identifier (URI) Dialing
Video Calls
Visual Voicemail
Voicemail
Related Topics
Enhanced Line Mode and Session Line Mode Environments, on page 207
Enable Intelligent Proximity
Note This procedure only applies to Bluetooth enabled phones. Cisco IP Phone 8811, 8841, 8851NR, and
8865NR do not support Bluetooth.
Intelligent Proximity enables users to take advantage of the acoustic properties of the phone with their mobile
device or tablet. The user pairs the mobile device or tablet to the phone using Bluetooth.
With a mobile device paired, the user can place and receive mobile calls on the phone. With a tablet, the user
can route the audio from the tablet to the phone.
Users can pair multiple mobile devices, tablets, and a Bluetooth headset to the phone. However, only one
device and one headset can be connected at the same time.
Procedure
Step 1 In Cisco Unified Communications Manager Administration, select Phone > Device.
Step 2 Locate the phone you want to modify.
Step 3 Locate the Bluetooth field and set the field to Enabled.
Step 4
Locate the Allow Bluetooth Mobile Handsfree Mode field, and set the field to Enabled.
Step 5 Save the changes and apply them to the phone.

Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager

244
Supported by Firmware Release 11.5(1) and later
Yes
Yes
Yes
Yes
Yes
Yes
Yes