Selecting Ecg Waveforms For Display - ZOLL Propaq MD Operator's Manual

C 6 M
HAPTER ONITORING

Selecting ECG Waveforms for Display

You can fit up to four waveforms on the Propaq MD display. The first waveform at the top of
the display is always an ECG waveform. (If
to automatically default to another ECG lead.) In the following example, Lead
the source of the ECG waveform trace:
06/06/2012
I, II,
III...
12
CO
2
IBP
Analyze
The X Series unit is configured to display
unit can also display four ECG traces on startup, when no other monitoring devices are
attached.
The are two ways to specify which ECG lead is the source of the primary waveform trace. One
way is to press the ECG lead selection quick access key
waveform sources. The available waveform sources are determined by the type of ECG cable
connected to the unit.
The other way to specify the source of the primary waveform trace is to navigate to and select
the source label for the primary ECG waveform (Lead
unit then displays the available ECG waveform sources. The following example illustrates the
waveform source list that the Propaq MD unit displays when a 5-lead ECG cable is connected
to it. The list of available ECG waveform sources includes Leads
You can select Lead
displayed ECG lead as the source for the waveform trace.
6-6
ECG
lI (the default), or use the navigation keys to highlight and select another
www.zoll.com
Pads are not connected, the unit can be configured
Pads by default for the top trace. If configured, the
I, II,
to display the available ECG
III...
l in the screen below). The Propaq MD
,
I
II (RA-LL), is
, , , , , and
II III aVR aVL aVF
9650-0806-01 Rev. D
.
V