C
3 D
HAPTER
ISASSEMBLY
Removing the Display Module
Tools Required
#1 Phillips screwdriver with torque capability
•
3M copper adhesive tape
•
6mm socket wrench
•
Setup
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
•
1. "Disassembling the Main Unit" on page 56
2.
To reinstall the display module, reverse the steps.
Display Disassembly
1
2
3
60
P
ROCEDURES
"Removing the Front Enclosure Module" on page 58
Place the back of the unit down on the mat
so that the display screen is facing up.
Remove the six (6) screws from the front of
the casting in the areas illustrated.
Note: During reassembly, torque screws to
6 in-lbs.
Flip the unit over and remove the
grounding screw for EtCO
2
illustrated.
in the area
9650-000821-01 Rev. C