Constant Metronome Disabled; Cpr Dashboard - ZOLL Propaq MD Operator's Manual

Constant Metronome Disabled

AED Mode
If Enable Metronome is set to Always or AED Mode Only, the metronome is active when
•
chest compressions are first detected during the CPR interval.
If set to Never, the metronome is silent.
•
Advisory/CPR Protocol or Manual Mode
If Enable Metronome is set to Always, the metronome is active only when the reported
•
compression rate falls below 80 cpm during the CPR period. If the chest compression sensor
is connected, the metronome is suspended after compressions have not been detected for at
least 2 seconds.
If set to Never or AED Mode Only, the metronome is silent.
•
The following table indicates when the CPR metronome is active.
Enable
Metronome
Setting
Constant Metronome Enabled
AED Mode
Only
Always
Never
Constant Metronome Disabled
AED Mode
Only
Always
Never

CPR Dashboard

Whenever CPR-D-padz or OneStep electrodes are connected to the Propaq MD defibrillator
and it senses compression, the unit illuminates the CPR Dashboard in the lower center portion
of the display. This field includes the CPR feedback indicators described in the following
sections.
9650-0806-01 Rev. D
AED Mode
On when CPR detected
Off when CPR Idle
On when CPR detected
Off when CPR Idle
Off
On at start of CPR period
On at start of CPR period
Off
CPR Release Indicator
Propaq MD Operator's Guide
Advisory/CPR
Protocol Mode
Off
On when CPR detected
Off when CPR Idle
Off
Off
On only at <80
compressions per minute
Off
Chest Compression
Indicator
CPR Dashboard
Manual Mode
Off
On when CPR detected
Off when CPR Idle
Off
Off
On only at <80
compressions per minute
Off
19–3