Applying A Reusable Spo 2 Sensor/Cable - ZOLL Propaq MD Operator's Manual

Applying a Reusable SpO
The following instructions describe how to apply a reusable Rainbow sensor. For all other
reusable sensors, refer to the sensor packaging and the manufacturer's Directions for Use for
instructions on how to apply the sensor.
Note:
After selecting a monitoring site, apply the reusable sensor as follows:
1. Place the selected digit over the sensor window, making sure that the sensor cable runs over
the top of the patient's hand.
On finger sites, make sure the tip of the finger touches the raised digit stop inside the sensor.
2.
If the fingernail is long, it may extend over and past the finger stop.
Check the sensor position to ensure that the top and bottom halves of the sensor are parallel.
3.
To ensure accurate data, you must have complete coverage of the detector window.
Note:
Based on the type of patient cable you are using, do one of the following:
4.
If you are using a direct one-piece patient cable, see "Connecting the SpO
•
page 10-8.
If you are using the two-piece patient cable, lift the clear plastic protective cover from
•
the female end of the extension cable, then plug the sensor cable's male connector into
the extension cable connector -- make sure that the plug is all the way into the connector
(see Figure 10-1).
Lower the clear plastic cover over the connection to secure it (see Figure 10-2).
5.
See "Connecting the SpO
6.
9650-0806-01 Rev. D
Sensor/Cable
2
A reusable sensor is not intended for use on the thumb or across a child's hand or foot.
With smaller digits, the digit may not need to be pushed all the way to the stop to
completely cover the detector window.
Sensor" on page 10-8 to connect the cable to the unit.
2
Propaq MD Operator's Guide
Applying the SpO Sensor
2
Sensor" on
2
10-7