Starting And Stopping Operation - Omron E5EK - MANUAL 2 User Manual

CHAPTER 3 BASIC OPERATION

3.6 Starting and Stopping Operation

' Manipulated vari-
able at stop
Setting Example
1 second min.
3–14
You can start and stop operation by changing the setting of the run/
stop" parameter (level 0 mode).
You can switch the RUN/STOP function up to 100,000 times.
To stop operation, set the run/stop" parameter to [
stop state, the STOP" LED lights.
Operation cannot be stopped during auto tuning.
Specify the manipulated variable ( 5.0 to 105.0%) in the MV at stop"
parameter (level 2 mode) to output the manipulated variable during
stop.
Factory set to 0.0 : 0.0%"
The following example describes the procedure to follow to stop control
during operation of the controller.
(1) Select the menu display, and select [
or keys. For details on selecting the menu display, see page
1 7.
(2) Press the key for one second minimum to enter the level 0 mode.
The PV and SP are displayed.
(3) Press the key until [
(4) Press the key to select [
and operation stops.
To resume operation, follow the above procedure to select [
The STOP" LED goes out and operation starts.
] (level 0 mode) using the
] (run/stop" parameter) is displayed.
] (stop). The STOP" LED lights,
] (stop). In a
] (run").