This Panel - Honeywell XLS80e Manual

XLS80e Fire Alarm Control Panels
TYPICAL ERROR MESSAGE:
ONE OF:
STATION 0 ONLY
STATIONS 1 TO 7 ONLY
TYPICAL ERROR MESSAGE:
The following error messages may be
displayed for a few seconds:
a. 'ERROR - Can't change the type of THIS
panel'. You cannot delete the panel which
has a tick in the 'this panel' column, or
change it to a repeater.
b. 'This station can only be a repeater'. You
cannot set stations 8 to 31 to a slave. This
message does not appear if the station is
the last one, since the type can be edited
(the option to delete is available).
c. 'This Panel type is set automatically'.
Station 0 is always Master or Stand-alone,
as appropriate.

14.2.2 THIS Panel

Note: The procedure to configure the
Repeater identity is given in the
Repeater manual.
Each panel must be told its own identity:
1 Use the
move the cursor to the appropriate row in
the 'this panel' column.
2 Select YES followed by
identity of THIS panel.
The tick moves from its previous position to
the current line.
The following error messages may be
displayed for a few seconds:
a. 'This panel is already set to be SLAVE n'.
There is already a tick on this row.
b. 'ERROR: Configuring this panel: Cannot be
a REPEATER'. The cursor is on a repeater
or a non-existent station.
121
pushbuttons to
to confirm the
Honeywell, Issue 9
March 2007