Using The Off-Line Support Tool; Passcodes - Honeywell XLS80e Manual

XLS80e Fire Alarm Control Panels
Access 2
* *
Access 3
* * *
Access 3A
* * * * *
*

3.4 Using the Off-line Support Tool

This is a means of preparing the configuration
data, using an optionally-supplied software tool
which you can use without any connection to
the panel:
i. Save the prepared data to your PC hard disk.
ii. When the panel is ready to accept the
configuration data, simply connect it to your
PC, for the final data transfer to be made.
The XLS80e Off-line Support Tool is a complete
package for off-line configuration preparation. It
is supplied with all necessary panel configuration
instructions, consequently no further details are
given here.
This software package is available from
HONEYWELL or your supplier (Part Number:
020-558-100).

3.5 Passcodes

A passcode is required for all configuration
functions. You will be asked for the passcode
at the appropriate time (Sections 4.4.1 and 12.1
give examples). There are three access
passcodes:
Access 2 - Permits operation of the panel
pushbutton controls and provides access to
all menus except the Configuration menu.
It can be overridden by the panel keyswitch.
Note: Some menus have options which can
only be accessed using an Access 3 or
Access 3A passcode; these options are
described in Section 12.
Access 3 - Provides access to the
Configuration menu. Most operations
described in this manual require this
passcode.
Access 3A - Certain operations (changing
passcodes, and panel settings) require this
passcode.
Default passcodes are supplied with the panel.
These can be changed and the manufacturer
strongly recommends that you do so once
commissioning has been completed (see
Section 8 for default passcodes and the means
of changing the passcodes from these defaults).
Passcodes are not required for off-line
configuration using a PC, but they are required
when uploading or downloading configuration
data using this method.
13 Honeywell, Issue 9
March 2007