Honeywell XLS80e Manual page 73

Honeywell, Issue 9
March 2007
XLS80e Fire Alarm Control Panels
9 If the 'Specified Individual Device' option is
selected at Step 1 specify the panel and its
device.
10 If the 'Virtual Input Point' option is selected
at step 1, use the zone and point numbers
to select the required point. The Virtual
Input Point text is displayed beside each
point; press the
'Located in Zone n', where 'n' is the point's
zone number (if there is no zone text
configured the zone number is always
displayed).
Note: Remote panels - enter the point's
number. No check is made on whether
the point is in a zone.
11a If the local panel is selected, specify
whether the Control Matrix rule is to apply
for Normal or Fallback network operation
11b Selecting ANY panel at Step 8, specify
SENSOR or MODULE.
12 Select device from ANY zone, or from a
specific zone, or from a range of up to 32
zones (select first zone and use the
pushbutton to extend the selection;
selected zones are shown in inverse text).
CELL
If you selected CELL instead of ZONE, enter
the cell number in the specified range. Device
coincidence is available but limited to two
devices. No further options are provided; for
cells the input device is always ANY INPUT
DEVICE TYPE.
THERMAL-ONLY ALARM
The Multi-criteria sensors can be selected by
zone (Any or specified) or by individual device.
Device coincidence is available BUT ONLY
FOR 2 DEVICES. No other options are provided.
66
button to display