Introduction; Associated Documents; System Design And Planning - Honeywell XLS80e Manual

XLS80e Fire Alarm Control Panels
Sensors and/or MCPs
EN54-2: 13.7
Maximum of 512
per panel unless
ELIBs are used
1

Introduction

This manual provides recommended procedures
for the successful configuration of a complete
Honeywell XLS80e Series integrated Fire Control
System (including repeater panels). The
procedures also apply for XLS80e Series
stand-alone Fire Control units.
The XLS80e Series intelligent fire alarm
controllers are designed for use with
Honeywell's range of addressable analogue
sensors, control and monitoring modules and
addressable call points. A unique signalling
protocol is used, with digital address and
control signals and analogue pulse width
monitoring for the reply data from devices.
The serial communications interface operates
under RS485 protocol. It enables the
connection between control panels and
repeaters.

1.1 Associated Documents

This manual should be read in conjunction with
the following documents:
a. XLS80e
Commissioning Manual
b. XLS80e Series Operating Manual
(ref. 997-474-000-x).

1.2 System Design and Planning

It is assumed that the system, of which the
XLS80e Series fire control equipment is a part,
has been designed by a competent fire alarm
system designer in accordance with the
requirements of EN54 Part 14, BS 5839 Part 1:
1988 and any other local codes of practice that
are applicable.
Be aware that....
This manual is not intended to be a fire
detection system design guide and should only
be used by (or under the supervision of) a
qualified system design engineer.
Some features of the XLS80e Series control
panel may, if used inappropriately, contravene
the requirements of EN54. Where there is a
possibility of such an occurrence, a suitable
warning is given with brief details of the EN54
requirement. A typical EN54 non-compliance
warning is illustrated at left.
1
Series Installation
Honeywell, Issue 9
March 2007
&