Dodge 2001 Ram 1500 Owner's Manual page 2216

BR/BE
OVERRUNNING CLUTCH CAM/OVERDRIVE PISTON RETAINER (Continued)
Fig. 188 Overrunning Clutch Cam
1 - PIN PUNCH
2 - REAR SUPPORT BOLT HOLES
Replace the drum and race as an assembly if
either component is damaged.
Examine the overdrive piston retainer carefully for
wear, cracks, scoring or other damage. Be sure the
retainer hub is a snug fit in the case and drum.
Replace the retainer if worn or damaged.
ASSEMBLY
(1) Temporarily install overdrive piston retainer in
case. Use 3-4 bolts to secure retainer.
(2) Align and start new clutch cam in the trans-
mission case. Be sure serrations on cam and in case
are aligned (Fig. 189). Then tap cam into case just
enough to hold it in place.
Fig. 189 Positioning Replacement Clutch Cam In
1 - ALIGN SERRATIONS ON CAM AND IN CASE
2 - CLUTCH CAM
Case
AUTOMATIC TRANSMISSION - 46RE
(3) Verify that cam is correctly positioned before
proceeding any further. Narrow ends of cam ramps
should be to left when cam is viewed from front end
of case (Fig. 189).
(4) Insert Adapter
retainer (Fig. 190).
(5) Assemble Puller Bolt SP-3701 and Press Plate
SP-3583-A (Fig. 191).
Fig. 190 Positioning Adapter Tool In Overdrive
Piston Retainer
1 - PISTON RETAINER
2 - SPECIAL TOOL SP-5124
Fig. 191 Assembling Clutch Cam Puller Bolt And
Press Plate
1 - PULLER BOLT SP-3701
2 - PRESS PLATE SP-3583-A
21 - 581
Tool SP-5124 into piston