Dodge 2001 Ram 1500 Owner's Manual page 2539

21 - 904 TRANSFER CASE - NV241HD
TRANSFER CASE - NV241HD (Continued)
1 - LOCK RING
2 - THRUST WASHERS
3 - PLANETARY CARRIER
4 - PTO GEAR
5 - BEARING
The planetary carrier cannot be disassembled. It
must be serviced as an assembly if damaged. Check
condition of the pinion teeth and PTO gear teeth. If
pinion tooth wear is evident, it will also be necessary
to check condition of the annulus gear teeth.
ASSEMBLY
BEARINGS AND SEALS
(1) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing from case from inside annu-
lus gear opening (Fig. 42).
(2) Install locating ring on new bearing.
(3) Position case so that the forward end is facing
upward.
(4) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing into case. The bearing
locating ring must be fully seated on case (Fig. 43).
Fig. 41 Planetary And Input Gear Components
6 - RETAINING RING
7 - SUPPORT SLEEVE
8 - INPUT GEAR
9 - RETAINING RING
Fig. 42 Input Shaft Bearing Removal
1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL C-4210
BR/BE