Dodge 2001 Ram 1500 Owner's Manual page 1860

BR/BE
OVERDRIVE UNIT (Continued)
ASSEMBLY
GEARTRAIN AND DIRECT CLUTCH
(1) Soak direct clutch and overdrive clutch discs in
Mopar ATF +4, type 9602, transmission fluid. Allow
discs to soak for 10-20 minutes.
(2) Install new pilot bushing and clutch hub bush-
ing in output shaft if necessary (Fig. 147). Lubricate
bushings with petroleum jelly, or transmission fluid.
Fig. 147 Output Shaft Pilot Bushing
1 - OUTPUT SHAFT HUB
2 - OVERRUNNING CLUTCH HUB BUSHING
3 - INTERMEDIATE SHAFT PILOT BUSHING
(3) Install annulus gear on output shaft, if
removed. Then install annulus gear retaining snap-
ring (Fig. 148).
Fig. 148 Annulus Gear Installation
1 - SNAP-RING
2 - OUTPUT SHAFT FRONT BEARING
3 - ANNULUS GEAR
AUTOMATIC TRANSMISSION - 42RE
(4) Align and install clutch drum on annulus gear
(Fig. 149). Be sure drum is engaged in annulus gear
lugs.
(5) Install clutch drum outer retaining ring (Fig.
149).
Fig. 149 Clutch Drum And Outer Retaining Ring
Installation
1 - ANNULUS GEAR
2 - OUTER SNAP-RING
3 - CLUTCH DRUM
(6) Slide clutch drum forward and install inner
retaining ring (Fig. 150).
(7) Install rear bearing and snap-ring on output
shaft (Fig. 151). Be sure locating ring groove in bear-
ing is toward rear.
Fig. 150 Clutch Drum Inner Retaining Ring
Installation
1 - ANNULUS GEAR
2 - INNER SNAP-RING
3 - CLUTCH DRUM
21 - 225