Dodge 2001 Ram 1500 Owner's Manual page 2541

21 - 906 TRANSFER CASE - NV241HD
TRANSFER CASE - NV241HD (Continued)
(9) Remove seal from front bearing retainer with
suitable pry tool.
(10) Install new oil seal in front bearing retainer
with Installer 7884 (Fig. 47).
Fig. 47 Install Front Bearing Retainer Seal
1 - FRONT BEARING RETAINER
2 - SPECIAL TOOL 7884
(11) Remove seal from oil pump with suitable pry
tool.
(12) Install new seal in oil pump with Installer
7888 (Fig. 48).
Fig. 48 Install Oil Pump Seal
1 - HOUSING SEAL
2 - SPECIAL TOOL 7888
3 - OIL PUMP FEED HOUSING
(13) Inspect carrier needle bearing. If bearing is
worn, rough, or damaged in any way, remove it with
a brass punch and hammer (Fig. 49).
Fig. 49 Carrier Needle Bearing Removal
1 - BRASS PUNCH
2 - CARRIER NEEDLE BEARING
(14) Install new needle bearing in planetary car-
rier (Fig. 50). Use Handle C–4171 and Installer 5062
to install bearing.
Fig. 50 Planetary Carrier Needle Bearing Installation
1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL 5062
3 - CARRIER BEARING
(15) Remove input gear pilot bearing by inserting
a suitably sized drift into the splined end of the input
gear and driving the bearing out with the drift and a
hammer (Fig. 51).
(16) Install new pilot bearing with Plug C-293-3.
(17) Remove the output shaft rear bearing with
the screw and jaws from Remover L-4454 and Cup
8148 (Fig. 52).
BR/BE