Dodge 2001 Ram 1500 Owner's Manual page 1916

BR/BE
VALVE BODY (Continued)
BOOST VALVE
The boost valve (Fig. 266) provides increased fluid
apply pressure to the overdrive clutch during 3-4
upshifts (Fig. 267), and when accelerating in fourth
gear. The boost valve also serves to increase line
pressure during torque converter lock-up.
Fig. 266 Boost Valve Before Lock-up
Fig. 267 Boost Valve After Lock-up
AUTOMATIC TRANSMISSION - 42RE
REMOVAL
The valve body can be removed for service without
having to remove the transmission assembly.
The valve body can be disassembled for cleaning
and inspection of the individual components.
The only replaceable valve body components are:
• Manual lever.
• Manual lever washer, seal, E-clip, and shaft
seal.
• Manual lever detent ball.
• Throttle lever.
• Fluid filter.
• Pressure adjusting screw bracket.
• Governor pressure solenoid.
• Governor pressure sensor (includes transmission
temperature thermistor).
• Converter clutch/overdrive solenoid assembly
and harness .
• Governor housing gasket.
• Solenoid case connector O-rings.
(1) Shift transmission into NEUTRAL.
(2) Raise vehicle.
(3) Remove gearshift and throttle levers from shaft
of valve body manual lever.
(4) Disconnect wires at solenoid case connector
(Fig. 268).
(5) Position drain pan under transmission oil pan.
(6) Remove transmission oil pan and gasket.
(7) Remove fluid filter from valve body.
(8) Remove bolts attaching valve body to transmis-
sion case.
(9) Lower valve body enough to remove accumula-
tor piston and springs.
(10) Work manual lever shaft and electrical con-
nector out of transmission case.
(11) Lower valve body, rotate valve body away
from case, pull park rod out of sprag, and remove
valve body (Fig. 269).
Fig. 268 Transmission Case Connector
1 - SOLENOID CASE CONNECTOR
2 - PARK/NEUTRAL POSITION SWITCH
21 - 281