Dodge 2001 Ram 1500 Owner's Manual page 2206

BR/BE
OVERDRIVE UNIT (Continued)
Fig. 154 Overrunning Clutch Installation
1 - CLUTCH DRUM
2 - OVERRUNNING CLUTCH ASSEMBLY
3 - EXPANDING-TYPE SNAP-RING PLIERS
4 - CLUTCH DRUM
5 - ANNULUS GEAR
6 - OVERRUNNING CLUTCH ASSEMBLY SEATED IN OUTPUT
SHAFT
Fig. 155 Planetary Gear Installation
1 - PLANETARY GEAR
2 - ANNULUS GEAR
AUTOMATIC TRANSMISSION - 46RE
(13) Install planetary thrust bearing on sun gear
(Fig. 156). Slide bearing onto gear and seat it against
spring plate as shown. Bearing fits one way only. If it
does not seat squarely against spring plate, remove
and reposition bearing.
(14) Install assembled sun gear, spring plate and
thrust bearing (Fig. 157). Be sure sun gear and
thrust bearing are fully seated before proceeding.
Fig. 156 Planetary Thrust Bearing Installation
1 - SPRING PLATE
2 - PLANETARY THRUST BEARING
3 - SUN GEAR
Fig. 157 Sun Gear Installation
1 - SUN GEAR AND SPRING PLATE ASSEMBLY
(15) Mount assembled output shaft, annulus gear,
and clutch drum in shop press. Direct clutch spring,
hub and clutch pack are easier to install with assem-
bly mounted in press.
(16) Align splines in hubs of planetary gear and
overrunning clutch with Alignment tool 6227-2 (Fig.
158). Insert tool through sun gear and into splines of
21 - 571