Remounting - Suzuki LT-Z250 Service Manual

Remove the screw 7 and washers 8.
Remove the knob 9.
Disconnect the cable by removing the rotor 0.

REMOUNTING

Remount the reverse lock release cable in the reverse order of
removal. Pay attention to the following points:
Install the spring so that the spring end A matches the groove
B on the housing.
Apply SUZUKI SUPER GREASE to the O-ring 1.
& 99000-25030: SUZUKI SUPER GREASE A (USA)
99000-25010: SUZUKI SUPER GREASE A (Others)
Install the O-ring 1 to the reverse lock release cable 2.
Connect the cable to the rotor 3 through the hole of the hous-
ing.
NOTE:
* When installing the rotor, hook the spring end C on the con-
cave portion D of the rotor.
* Make sure that the reverse lock release cable is routed cor-
rectly.
CHASSIS 7-65