Reassembly - Suzuki LT-Z250 Service Manual

7-58 CHASSIS
SWINGARM PIVOT BEARING
Insert the spacer into the swingarm pivot bearings and then
check the play by moving the spacer up and down.
If excessive play is noted, replace the bearing with a new one.
Remove the swingarm pivot bearing with the special tools.
% 09923-74510: Bearing remover
09930-30104: Sliding shaft
$
The removed bearing must be replaced with a new
one.

REASSEMBLY

SWINGARM PIVOT BEARING AND DUST SEAL
Press the bearing into the swingarm pivot to the depth of 5.0
mm (0.197 in) from the outside with the special tool and suit-
able socket wrench.
NOTE:
When installing the swingarm pivot bearing, make sure that the
stamped mark faces outside.
% 09924-84510: Bearing installer set
Apply SUZUKI SUPER GREASE to the bearings, spacers
and ips of the dust covers.
& 99000-25030: SUZUKI SUPER GREASE A
99000-25010: SUZUKI SUPER GREASE A
Install the spacers and dust covers to the swingarm.
5.0 mm (0.197 in)
(USA)
(Others)
5.0 mm (0.197 in)