Suzuki LT-Z250 Service Manual page 116

3-74 ENGINE
Install the camshaft and camshaft sprocket.
Engage the hole of the sprocket C with the locating pin on the
camshaft as shown.
Align the lines D on the camshaft so that they are parallel
with the surface of the cylinder head.
NOTE:
* Do not rotate the generator while doing this. When the
sprocket is not positioned correctly, turn the sprocket.
* While aligning the lines D, remove chain slack by turning the
sprocket counterclockwise lightly.
Install the C-ring 1.
Install the lock washer as it covers the locating pin.
Apply THREAD LOCK SUPER to the bolts and tighten them
to the specified torque.
* 99000-32030: THREAD LOCK SUPER 1303
" Camshaft sprocket bolt: 11 N•m (1.1 kgf-m, 8.0 lb-ft)
Bend up the washer tongue to lock the bolts.
2 Camshaft
3 Pin
4 Bolt
5 Lock washer
6 Camshaft sprocket