Brake Disc Inspection; Brake Disc Reassembly And Remounting - Suzuki LT-Z250 Service Manual

BRAKE DISC INSPECTION

Remove the front wheel. (!7-10)
Remove the caliper. (!7-19)
Inspect the brake disc for cracks or damage and measure the
thickness using the micrometer. If any damages are found or if
the thickness is less than the service limit, replace the brake disc
with a new one.
% 09900-20205: Micrometer (0
' Brake disc thickness
Service Limit: 2.5 mm (0.098 in)
Measure the runout using the dial gauge. If the runout exceeds
the service limit, replace the brake disc with a new one.
% 09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
' Brake disc runout
Service Limit: 0.3 mm (0.012 in)
If either measurement exceeds the service limit, replace the
brake disc with a new one.
BRAKE DISC REASSEMBLY AND
REMOUNTING
Reassemble and remount the brake disc in the reverse order of
removal and disassembly. Pay attention to the following points:
Install the disc to the wheel hub with the punching letters A
on the disc showed up.
NOTE:
Make sure that the disc is clean and free of any greasy matter.
Apply THREAD LOCK SUPER to the brake disc bolts and
tighten them to the specified torque.
+ 99000-32130: THREAD LOCK SUPER 1360
" Brake disc bolt: 23 N•m (2.3 kgf-m, 16.5 lb-ft)
Install the front wheel hub. (!7-14)
Install the front wheel. (!7-15)
25 mm)
CHASSIS 7-25