Suzuki LT-Z250 Service Manual page 95

INSPECTION
Inspect the removed parts for the following abnormalities.
* Drive and driven bevel gears damage or wear
* Improper tooth contact
* Abnormal noise of bearings
* Bearing damage or wear
* Oil seal damage or wear
SECONDARY DRIVEN BEVEL GEAR REASSEMBLY
Install the bearing.
NOTE:
Pay attention to the direction of the bearing.
Install the shim 1, driven gear and washer 2.
Fit the universal joint onto the driven bevel gear shaft.
Tighten the driven bevel gear nut to the specified torque.
" Secondary driven bevel gear nut:
Stake the nut with a center punch.
Install the bearing.
NOTE:
Pay attention to the direction of the bearing.
100 N•m (10.0 kgf-m, 72.5 lb-ft)
ENGINE 3-53