Suzuki LT-Z250 Service Manual page 94

3-52 ENGINE
SECONDARY DRIVEN BEVEL GEAR REMOVAL
The following components must be removed in the described
order before removing the secondary driven bevel gear.
NOTE:
Refer to the following pages for the details of each step.
Remove the rear wheel. (!7-11)
Remove the swingarm. (!7-56)
Remove the universal joint.
Remove the secondary driven bevel gear.
SECONDARY DRIVEN BEVEL GEAR DISASSEMBLY
Remove the water proof cover 1 by removing the snap ring.
& 09900-06107: Snap ring pliers
Remove the oil seal 2 and bearing 3.
Using a chisel, unlock the nut.
Fit the universal joint onto the driven bevel gear shaft.
Remove the driven bevel gear shaft by holding the universal
joint with a vise.
Remove the washer 4, bevel gear 5, shim 6 and bearing
7.