Removing And Installing Rear Wheel Housing Crash Sensors (4-Door) - Volkswagen Golf 2004 Workshop Manual

6.4.2 Installing
– Install in reverse order of removal.
– Switch ignition on.
WARNING
Ensure that nobody is in the vehicle.
– Reconnect vehicle battery ⇒ Rep. Gr. 27 .
6.5 Removing and installing rear wheel
housing crash sensors (4-door)
Note
Removal and installation is described for the right vehicle side.
Follow same instructions for the left side as appropriate.
6.5.1 Removing
WARNING
Observe the general safety regulations when working on air‐
bag, belt tensioner and battery isolator units (pyrotechnic com‐
ponents) ⇒ page 90
– Disconnect vehicle battery ⇒ Rep. Gr. 27 .
– Remove bench seat
Vehicles ▸06/2005
– Remove side padding (4-door):
♦ With rear side airbags
♦ with no rear side airbags
– Remove wheel housing trim (4-door)
Vehicles with rear side airbag, 06/2005▸
– Remove side padding (4-door):
♦ with rear side airbags
– Remove wheel housing trim (4-door)
Vehicles without rear side airbag, 06/2005▸
– Remove wheel housing trim, 4-door, without rear side airbag
⇒ page 85 .
– Press connector securing device -1- to rear -arrow- and pull
connector -2- off crash sensor -4-.
– Remove the two bolts -3- (9 Nm).
⇒ page 304 .
⇒ page 306
⇒ page 307
⇒ page 84
⇒ page 306
⇒ page 84
Golf 2004 ➤ , Golf 2009 ➤
General body repairs, interior - Edition 05.2010
181
6. Crash sensors