Removing And Installing Rear Side Airbag Crash Sensors On Driver Side G256 / G257 - Volkswagen Transporter 2016 Workshop Manual

Transporter 2016 ➤
General body repairs, interior - Edition 03.2020
– Disconnect connector -2-.
– Unscrew bolt -3-.
– Detach side airbag crash sensor on driver side - G179- -1-.
– Disconnect connector -2-.
Installing
– Install in reverse order of removal, observing the following:
– Switch on ignition.
– Connect earth wire at battery negative terminal ⇒ Electrical
system; Rep. gr. 27 ; Battery; Disconnecting and connecting
battery .
Specified torques
♦ ⇒ "9.1 Overview of fitting locations - airbag crash sensors",
page 172
9.3 Removing and installing rear side airbag
crash sensors on driver side - G256- / -
G257-
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1783-
Removing
Caution
Pyrotechnic components can trigger unintentionally.
Discharge any static electricity in body by briefly touching door
striker plate.
– Switch on ignition.
– Disconnect earth wire at battery negative terminal ⇒ Electrical
system; Rep. gr. 27 ; Battery; Disconnecting and connecting
battery .
Removing rear side airbag crash sensor on driver side - G256-
– Remove luggage compartment side trim
174
Rep. gr.69 - Passenger protection
⇒ page 259 .