Figure 26: Insert Switch Into Frame - Mellanox Technologies SwitchX-2 MSX6005F-1BFS Hardware User Manual

12 port infiniband switch system
Table of Contents

Advertisement

Rev 1.0
6. Tighten the capture nuts.
7. Install the blank panel into the frame opposite the switch, or install a second switch.
8. Tighten the capture nuts.
9. Tighten all ten screws to 9.2 Nm or 81.5 pound inches.
10. Ground the switch.
11. Plug in the power cables. Wait at least 2 seconds between inserting the first power supply
cord and inserting the second power supply cord.
12. You can start connecting all of the cables to the switch.
38
Mellanox Technologies

Figure 26: Insert Switch into Frame

Wait at least 2 seconds between inserting the first power supply cord and
inserting the second power supply cord.
Anytime the switch is powered down (by choice or by power failure) you must unplug
the 2 PSUs before powering up the system.
Installation

Advertisement

Table of Contents
loading

Table of Contents