Table of Contents
Advertisement
I N S T A L L A T I O N & S E T U P
This chapter explains how to install the verifier and connect all the
cables. You need a Phillips screwdriver and a 3/32 Hex key
(wrench).
Throughout this chapter, the reference to "knife setup" is for the 9860
printer; the reference to "non-knife setup" is for the 9855 printer.
The verifier does not work with a 9855 printer using the Monarch 926
knife.
I n s t a l l i n g t h e V e r i f i e r
1.
Turn off the printer.
2.
Place the printer on a firm work surface.
3.
Remove the following items from their packaging:
(1) base plate
(1) stand
(4) feet
(1) ¼" plain cork washer
(5) M4x12 screws with attached lock washers
(6) #10-32x1/4" set screws
4.
Turn the base plate upside down and attach the adhesive feet in each
corner. Make sure the base plate looks like the one pictured before
you attach the feet. Pay attention to the pattern of the mounting
holes.
(2) shafts
(1) mounting block
(1) L-bracket
(1) ¼"-20x1¼" screw
2
Installation & Setup 2-1
Advertisement
Table of Contents
