Avery Dennison Monarch Verifier 938 Operating Instructions Manual page 15

Paxar 938 monarch verifier product manual

Hide thumbs Also See for Monarch Verifier 938:

Table of Contents

10. Insert the horizontal shaft (with two different diameters) into the

mounting block as shown. Insert the set screws into the top of the

mounting block. Align the flat on the shaft with the set screws in the

mounting block.

For knife printers, the shaft should be flush with the left edge of the

mounting block.

For non-knife printers, insert the shaft so the step in the shaft is flush

with the right edge of the mounting block.

Knife Setup

Note:

Securely tighten ALL the set screws in the shaft and

mounting block with a 3/32 Hex key.

11. Look at the stand from above. Adjust the stand so the horizontal

shaft is parallel (aligned) with the front edge of the base plate.

Securely tighten the three screws attaching the stand to the base

plate.

Non-Knife Setup

Installation & Setup 2-5

Table of Contents

Monarch 938 verifier