Table of Contents
Advertisement
Consider this scenario when the error action is set to
overstrike/continue 3x:
If the printer errors on the first label, an overstrike pattern is printed, but
the printer attempts to reprint the image up to three times. If the third
consecutive label also generates an error, an overstrike pattern is
printed; however, the printer stops and the error message is displayed.
The operator must resolve the error condition before printing continues.
In the above example, if the third label did NOT generate an error,
♦
the batch image is printed
♦
the consecutive error counter is reset
♦
the printer continues processing the batch.
Normal (default)
Overstrike/Continue 1x
Overstrike/Continue 2x
Overstrike/Continue 3x
Overstrike/Continue 4x
Overstrike/Continue 5x
The printer errors and the condition causing
the error is displayed. The error must be
cleared before operation can continue.
An operator must press Escape/Clear to clear
the error and continue printing. No overstrike
pattern is printed.
The printer prints an overstrike pattern on one,
two, three, four, or five consecutive labels and
stops printing after the selected number of
overstrike patterns have been printed.
An operator must press Escape/Clear to clear
the error and continue printing. Do not use the
label with the overstrike pattern.
Note: The printer re-calibrates (feeds a blank
label) after a motion or verifier error.
Configuring the Printer 5-9
Advertisement
Table of Contents
