Table of Contents
Advertisement
O v e r v i e w
Have your System Administrator follow these steps before you use the
verifier:
Install and set up the verifier. See Chapter 2, "Installation & Setup,"
1.
for more information.
2.
Configure the verifier using ScanVision. See Chapter 3, "Configuring
the Verifier," for more information.
If necessary, create a verifier configuration file. See Chapter 4,
3.
"Using the VCT," for more information. A verifier configuration file
allows you to set the verifier to check only the parameters you select.
You should understand your application and which parameters you
want the verifier to check.
Configure the printer to enable the verifier. See Chapter 5,
4.
"Configuring the Printer," for more information.
Getting Started 1-3
Advertisement
Table of Contents
