Table of Contents
Advertisement
7.
Attach the L-bracket to the base plate with two screws:
For knife printers, attach the L-bracket to the left side of the base
plate.
For non-knife printers, attach the L-bracket to the center of the base
plate.
Knife Setup
Note:
Do not fully tighten these screws.
8.
Insert the vertical shaft into the stand until it stops. (The vertical
shaft has one diameter; the horizontal shaft has two different
diameters.)
Insert the set screws into the stand. Align the flat on the shaft with
the set screws in the stand.
Knife Setup
Note:
Securely tighten the set screws with a 3/32 Hex key.
Non-Knife Setup
Non-Knife Setup
Installation & Setup 2-3
Advertisement
Table of Contents
