Using The Vct - Avery Dennison Monarch Verifier 938 Operating Instructions Manual

4
U S I N G T H E V C T
This chapter explains how to use the Monarch Verifier
Configuration Tool (VCT) to create or modify a verifier configuration
packet. This tool can be downloaded from our Web site. To install,
follow the prompts as necessary.
The verifier supports Mode 2 and Mode 19, which are standard verifier
modes. Mode 2 specifies nine different parameters to verify: ANSI
defects, decodability, and grade; quiet zones; partial decodes, decode
errors, passing percent decode; minimum number of I2of5 digits; and no
read. Mode 19 specifies all parameters from Mode 2, plus contrast
grade, wide to narrow ratio, and minimum and maximum X-dimensions.
When you start the VCT, the different parameters are grouped by type,
ready for you to change.
Depending on your application and which parameters you want the
verifier to check, make your selections on the Verifier Hardware, Barcode
Evaluation and (if necessary) Additional Values screens.

Using the VCT 4-1