Table of Contents
Advertisement
Connect the other end of the I/O cable (with the 8-pin mini-din
8.
connector) to the back of the printer.
9.
Connect the communication cable to the port on your computer with
RJS ScanVision installed.
If the verifier's serial or I/O cable are disconnected from the
printer, the printer displays "773 Verifier Fail." See "Detecting the
Cable" for more information. Make sure the cables are connected
between the verifier and printer. If error 773 appears, press
Escape/Clear to clear the error.
Use the serial port on the computer to configure the verifier using
the RJS ScanVision software.
Verifier Connector
for I/O Cable
Use this 9-pin verifier port
for verifier to printer
connections
Use this 25-pin serial port for
computer to printer connections
Installation & Setup 2-11
Advertisement
Table of Contents
