Table of Contents
Advertisement
S e t u p
Verifier positioning and system setup are extremely important for proper
operation.
To control the verifier's beam (through the printer's offline menu), the
1.
9-pin serial cable must be connected between the printer and verifier.
2.
Turn on the printer. The verifier beam also turns on. See the
following graphics to align the beam properly.
Align the verifier's red beam with the white lines as shown.
3.
The proper angle for the verifier is 22°.
Ai m beam onto w hite line
2-12 Operating Instructions
Knife Setup
Advertisement
Table of Contents
