Table of Contents
Advertisement
9.
Repeat steps 5 and 6 until no more mounting adjustments are
required.
10. Remove the symbol from the laser beam path.
11. Calibrate the verifier if any reflectance parameters (such as symbol
contrast) are programmed in this application to report to a host or
activate any ports. Each verifier has a calibration label provided in
the box.
Note:
The SV Series Operator's Guide contains screen shots of the
RJS ScanVision software for your reference.
The verifier is ready to operate for parallel bar codes.
3-4 Operating Instructions
Advertisement
Table of Contents
