Table of Contents
Advertisement
V e r i f i e r E r r o r s
The printer re-calibrates (feeds a blank label) after a motion or verifier
error.
409
Printer memory is full. Delete unnecessary formats or graphics
from memory. You may need to format flash memory. From the
Main Menu, select Setup, Flash Memory, and Format Flash.
Formatting flash memory is only required once during initial
printer setup.
430
The format uses a graphic or verifier configuration packet that
cannot be found. See "Using the Verifier Field" for more
information.
764
Verifier scan error (bad scan) on label when using normal (no
overstrike) mode. Press Escape/Clear to clear the error and
continue printing. The printer re-calibrates (feeds a blank label)
after this error.
You can change how the verifier responds to an error.
See "Setting the Error Action," for more information.
Make sure you did not apply Option 62 (do not scan a particular
bar code) to all bar codes on a format. See "Defining Option 62,"
for more information.
772
Verifier scan error (bad scan) on label or multiple labels in a row
when using overstrike and continue mode. Press Escape/Clear
to clear the error and continue printing. The printer re-calibrates
(feeds a blank label) after this error.
You can change how the verifier responds to an error.
See "Setting the Error Action," for more information.
773
Verifier Failure – the verifier is enabled, but not connected.
The printer can detect if the I/O and/or serial cable are
connected to the verifier. See "Detecting the Cable" for more
information.
783
The printer is printing too fast for the verifier to accurately scan
the bar codes. Increase the bar code height in your formats or
slow the print speed.
6-2 Operating Instructions
Advertisement
Table of Contents
