Dodge dakota 2002 Service Manual page 1381

9 - 132 ENGINE - 4.7L
CRANKSHAFT (Continued)
Fig. 59 Cylinder Block-to-Bedplate
Sealent Bead Location
1 - CYLINDER BLOCK
2 - SEALANT BEAD LOCATION
(6) Coat the crankshaft main bearing journals
with clean engine oil and position the bedplate onto
the cylinder block.
NOTE: Lubricate the bedplate retaining bolts with
clean engine oil prior to installation.
(7) Install the bedplate retaining bolts, making
sure to place the stud bolts in the correct location,
Torque the bolts in the sequence shown (Fig. 60).
• Tighten bolts A – L to 54 N·m (40 ft. lbs.)
• Tighten bolts 1–10 to 2.8 N·m (25 in. lbs.)
• Turn bolts 1–10 an additional 90°.
• Tighten bolts A1– A6 to 27 N·m (20 ft. lbs.)
1 - BEDPLATE
ENGINE/ENGINE BLOCK/CRANKSHAFT - STAN-
DARD PROCEDURE).
clearance. (Refer to 9 - ENGINE/ENGINE BLOCK/
CONNECTING ROD BEARINGS - STANDARD
PROCEDURE).
using a new o-ring, install the oil pickup tube.
Torque the bolt to 28N·n (20 ft. lbs.) torque the nuts
to 28N·m (20 ft. lbs.).
15 N·m (11 ft. lbs.) in the sequence shown (Fig. 61).
INSTALLATION).
Fig. 60 Bedplate Tightening Sequence
2 - CYLINDER BLOCK
(8) Measure crankshaft end play. (Refer to 9 -
(9) Install the connecting rods and measure side
(10) Position the oil pan gasket/windage tray,
(11) Install the oil pan. Torque the retaining bolts to
Fig. 61 Oil Pan Tightening Sequence
(12) Install the engine (Refer to 9 - ENGINE -
DR