0180 Machine Number Mismatch; 0350 Panel Pwb Communication Error; 0620 Fax Image Dimm Error - Kyocera TASKalfa 3510i Service Manual

Code Contents
0180 Machine number mismatch
Machine number of main and
engine does not match.
0350 Panel PWB communication
error (electronic volume I2C
communication error)
NACK is received during I2C
communication -> retried 5
times -> rebooting command
sent -> retried 5 times
If NACK is still received.
0620 FAX image DIMM error
1. The Fax image DIMM has
not been installed.
2. Fax image DIMM access
error.
Related parts
Data damage of
EEPROM.
Operation PWB
Main PWB
Replace the main PWB (see page 1-5-38).
FAX image DIMM
Main PWB.
Replace the main PWB (see page 1-5-38).
1-4-15
Check procedures/
corrective measures
1. Confirm the machine data for the main
and engine units by using U004 (see
page 1-3-24).
2. If the serial number data of different
models is alternately displayed, install
the correct EEPROM in the PWB of the
wrong serial number data.
3. Contact the Service Support.
1. Turn the main power swtch off and after
5 seconds, then turn power on.
2. Confirm that the wiring connector is
firmly connected and, if necessary, con-
nect the connector all the way in.
Operation panel PWB 1 (YC10) and
Main PWB (YC12)
3. If the wiring is disconnected, shorted or
grounded, replace the wiring.
4. Replace the operation panel PWB 1
(see page 1-5-52).
1. Install the FAX image DIMM supplied in
the FAX system onto the main PWB.
2. Firmly install the FAX image DIMM again
onto the main board.
3. Check the FAX image DIMM terminals
and remove any foreign objects that may
be adhered to it.
4. Replace with a new FAX image DIMM.
2NL/2P8