Safety Instructions - Kollmorgen SERVOSTAR 601 Assembly And Installation Manual

Safety instructions

Safety Instructions
l
Only properly qualified personnel are permitted to perform activities such as
transport, installation, setup and maintenance. Properly qualified persons
are those who are familiar with the transport, assembly, installation, setup
and operation of the product, and who have the appropriate qualifications
for their job. The qualified personnel must know and observe:
l
Read this documentation before carrying out installation and setup.
Incorrect handling of the servo amplifier can lead to personal injury or
material damage. It is vital that you keep to the technical data and
information on connection requirements (on the nameplate and in the
documentation).
l
The manufacturer of the machine must generate a hazard analysis for the
machine, and take appropriate measures to ensure that unforeseen
movements cannot cause injury or damage to any person or property.
l
The servo amplifiers contain electrostatically sensitive components which
may be damaged by incorrect handling. Ground yourself before touching the
servo amplifier by touching any unpainted metal surface. Avoid contact with
highly insulating materials (artificial fabrics, plastic film etc.). Place the
servo amplifier on a conductive surface.
l
Do not open the units. Keep all covers and switchgear cabinet doors closed
during operation. Otherwise there are deadly hazards, with the possibility of
severe danger to health or material damage.
l
During operation, servo amplifiers, according to their degree of enclosure
protection, may have uncovered live components. Control and power
connections may be live, even if the motor is not rotating.
l
Servo amplifiers may have hot surfaces during operation. Since the front
panel is used for cooling, it can reach temperatures above 80°C (176°F).
l
Never undo the electrical connections to the servo amplifier while it is live.
There is a danger of electric arcing with damage to contacts and danger to
persons.
l
Wait at least five minutes after disconnecting the servo amplifier from the
mains supply voltage before touching live sections of the equipment (e.g.
contacts) or undoing connections. Capacitors can still have dangerous
voltages present up to five minutes after switching off the supply voltages.
To be sure, measure the voltage in the DC-link circuit and wait until it has
fallen below 40V.
6
IEC 364 and CENELEC HD 384 or DIN VDE 0100
IEC-Report 664 or DIN VDE 0110
National Accident Prevention Regulations or BGV A2
SERVOSTAR
03/04
®
601...620 Installation Manual
Kollmorgen