European Directives And Standards - Kollmorgen SERVOSTAR 601 Assembly And Installation Manual

Kollmorgen

European directives and standards

Servo amplifiers are components that are intended to be incorporated into electrical plant and machines for in-
dustrial use.
When the servoamplifiers are built into machines or plant, the intended operation of the amplifier is forbidden
until it has been established that the machine or plant fulfills the requirements of the EC Machinery Directive
98/37/EG and the EC Directive on EMC (89/336/EEC).
To fulfill the EC Machinery directive (98/37/EG), the following standards have to be applied:
EN 60204-1
EN 292
The manufacturer of the machine must produce a hazard analysis for the machine and take appropria-
te measures to ensure that unforeseen movements do not result in personal injury or material dama-
ge.
To fulfill the Low Voltage Directive 73/23/EEC, the following standards have to be applied:
EN 60204-1
EN 50178
EN 60439-1
To fulfill the EC EMC regulations (89/336/EEC), the following standards have to be applied:
EN 61000-6-1 or EN 61000-6-2 (noise immunity within the domestic range/industrial range)
EN 61000-6-3 or EN 61000-6-4 (noise emission within the domestic range/industrial range)
The manufacturer of the machine or plant is responsible for ensuring that they meet the limits required by the
EMC regulations. Advice on the correct installation for EMC – such as shielding, grounding, arrangement of
connectors and cable routing – can be found in this documentation.
The machine / plant manufacturer must examine whether with its machine / plant still further or other
standards or EEC guidelines are to be used.
Conformity
Conformity with the EC Directive on EMC 89/336/EEC and the Low Voltage Directive 73/23/EEC is mandatory
for servoamplifiers supplied within the European Union.
To fulfill the EMC directive, the standard EN 61800-3 is applied.
In the reference to noise immunity and noise emission the servoamplifier fulfills the requirement to the catego-
ry second environment (industrial environment).
The servo amplifiers have been tested by an authorized testing laboratory in a defined configuration with the
system components which are described in this documentation. Any divergence from the configuration and in-
stallation described in this documentation means that you will be responsible for carrying out new measure-
ments to ensure that the regulatory requirements are fulfilled.
To fulfill the Low Voltage Directive, the standard EN 50178 has to be applied.
®
SERVOSTAR 601...620 Installation Manual
(Safety and electrical equipment of machines)
(Safety of machines)
(Safety and electrical equipment of machines)
(Equipment of high voltage plant with electronic devices)
(Low-voltage switchgear and controlgear assemblies)
03/04
7