Table of Contents
Advertisement
Kollmorgen
4.2
Parameter setting
A default parameter set is loaded into your servo amplifier by the manufacturer. This contains valid
and safe parameters for the current and speed controllers.
A database for motor parameters is stored in the servo amplifier. During setup you must select the
data set for the motor that is connected and store it in the servo amplifier. For most applications
these settings will already provide good to very good control loop characteristics.
An exact description of all parameters and the possibilities for optimizing the control loop character-
istics can be found in the manual "Setup Software DRIVE.EXE".
4.2.1
Multi-axis systems
Using a special multilink cable, you can connect up to six servo amplifiers together and to your PC :
Cable type -SR6Y- (for 4 amplifiers) or -SR6Y6- (for 6 amplifiers)
With the PC connected to just one servo amplifier you can now use the setup software to select all
four / six amplifiers through the preset station addresses and set up the parameters.
PC
4.2.1.1
Node address for CAN-bus
During setup it makes sense to preset the station addresses for the individual amplifiers and the
baud rate for communication by means of the keypad on the front panel (ð p.59).
4.2.1.2
Baud rate for CAN-bus
After changing the station address and baud rate you must turn the 24V auxiliary supply of
the servo amplifier off and on again.
Coding of the baud rate in the LED display :
®
SERVOSTAR
601...620 Installation Manual
Cable -SR6Y-
COMx
RS232
Coding
Baud rate in kbit/s
0
10
1
20
2
50
3
100
4
125
03/04
X6
X6
PC/CAN
CAN
Add.:
Add.:
01
02
Baud rate identical for all amplifiers,
see table below
Coding
5
6
7
8
9
10
X6
X6
CAN
CAN
Add.:
Add.:
03
04
Baud rate in kbit/s
250
333
500
666
800
1000
Setup
57
Hide quick links:
Advertisement
Table of Contents
