Troubleshooting: Tape Feeding - Pitney Bowes Connect+ 500W Operator's Manual

Chapter 10
Possible Cause
There is a obstruction in the
moistener pad assembly area.

Troubleshooting: Tape Feeding

Description: Tape stoppage is occurring.
Possible Cause
Adhesive is left on the leading
l
edge of the new tap roll.
The leading edge of the tape is
l
rolled or folded under the tape
roller.
Description: System is not wetting gummed tape.
206
Solution
Check that there is enough E-Z
l
Seal® sealing solution in the
envelope sealant bottle.
Remove or lift the moistener
l
pad assembly. Verify that there
is no interference with the pad,
that the pad is wet and that
there is E-Z Seal® solution in
the small reservoir.
Check the envelopes, and
l
ensure that the contents are
tamped to the upper right hand
corner.
Solution
1. If necessary, remove the tape
roll.
2. Clear the tape stoppage.
3. Re-install the tape roll.
SV62589 Rev. C