Pitney Bowes Connect+ 500W Operator's Manual page 178

Chapter 9
4. Clean the moistening pad by running the pad under warm water.
5. Replace the existing clean moistener pad assembly, or install a new one by pushing the
assembly back on its track until it snaps into position.
NOTE: Verify that the moistener pad assembly is perfectly level with the feed deck.
6. Close the feed cover and select OK.
Connect+® 3000 Systems
1. Lift the feed cover.
2. Pull up on the top release lever.
3. Use the blue notch to pull on and open the moistener deck.
4. Grasp the moistener pad assembly and slide out and away from you.
174
SV62589 Rev. C