Tips For Aas - MUTOH VC-600 User Manual

Automatic Aligning System
Step 3
Print the Graphics

Print the graphic and the marks with your printer

When printing on a roll media, make sure the orientation as following:
Step 4

The Origin Mark is is different from the rest registration marks. Please make sure the media
is fed with correct direction.
Step 5
Cut the Contour

Send out the command from software to perform the contour cutting job.

5.6 Tips for AAS

For getting better results of contour cutting, there are some tips below for your reference.

Keep light sources simple and avoid illuminating from the sides of cutter.

Before operating AAS, change the maximum paper size in ValueCut driver property.
STEP 1 Find the ValueCut model in the "Printer & Fax" folder of your PC.
STEP 2 Open the Properties window and select the "Paper" tab.
STEP 3 Change the maximum Paper Size of X to 1200mm.

Adjust the cutting speed to between 300~600mm/sec.

Avoid the registration marks locating on the tracks of pinch rollers.
(Scaling = 100%).
60
ValueCut USER MANUAL
V5a 2015 Jan