Cargo Box; Taillight Assembly; Seat - Arctic Cat PROWLER HDX 2015 Service Manual

Cargo Box

REMOVING
1. Raise the cargo box; then remove the cap screw and
nut securing the lower lift support to the frame.
Account for the washer. The cargo box will tilt fully
rearward.
2. Loosen but do not remove the four shoulder cap
screws securing the pivot housings to the cargo box.
3. Lower the cargo box; then remove the four cap
screws (from step 2).
4. With the help of an assistant or an adequate lift,
remove the cargo box from the vehicle. Account for
four pivot housings.
CLEANING AND INSPECTING
1. Clean all cargo box components with soap and water.
2. Inspect the cargo box for cracks, tears, and loose
hardware.
3. Inspect the welds of the cargo box frame for cracking
or bending.
4. Inspect the cargo box gate latches for smooth opera-
tion.
INSTALLING
1. With the help of an assistant or an adequate lift, set
the cargo box into position on the frame; then posi-
tion the two upper pivot housings between the cargo
box and frame. Lightly grease the pivot housings.
2. Align the holes in the upper pivot housings with the
holes in the cargo box; then install the lower pivot
housings and secure with the four shoulder cap
screws. Tighten to 20 ft-lb.
3. Raise the cargo box; then connect the lift support to
the frame, install the cap screw and nut, and tighten
the nut securely.
4. Lower the cargo box and lock into position.

Taillight Assembly

REMOVING
1. Remove the cap screws and lock nuts securing the
taillight assembly to the ROPS tube.
HDX257
2. Disconnect the wire connector; then remove the
socket assembly and remove the bulb.
INSPECTING
1. Inspect wiring harness, three-prong connector, lens,
base, cap screws, and socket for damage.
2. Inspect all wires for corroding, pinching, and crack-
ing.
3. Inspect the bulb for wattage, voltage, and proper
operation.
INSTALLING
1. Install the new bulb in the socket and place the
socket assembly into the taillight housing. Twist
clockwise to lock.
PR335
2. Connect the wire connector; then install on the
ROPS tube and secure with two cap screws and lock
nuts. Tighten securely.
REMOVING/INSTALLING
1. To remove the seat, raise the front of the seat and
slide it forward.
2. To install the seat, slide the rear of the seat into the seat
retainers and push down firmly on the front of seat.

Seat

33