Hard Disk Copy Procedure; Connect Hdd - GE LOGIQ 5 PRO Service Manual

GE M S
EDICAL YSTEMS
D 2380207, R
IRECTION EVISION
8-8-3-6

Hard disk copy procedure

This section show the patient data duplication procedure for hard disk replacement The purpose od this
procedure is to copy the patient data in the used hard diks into the newly installed BEP or hard disk assy.
Caution : If the new hard disk have the patient data, these data should be back up with CD before data
copy procedure. Since the patient data will be overwritten into the new hard disk from used hard disk.
8-8-3-6-1

Connect HDD

1.) Set the used hard disk as slave mode disk. All the HDD have jumper for mode setting, master mode
or slave mode. For the patient data copy procedure, the both HDD should be set as master and
slave. The HDD in the installed BEP assy is the master. All of the HDD in BEP assy are set to master
in the factory. So the used HDD should be set to slave. Refer the figure of HDD jumper.
2.) Connect the IDE cable to HDD.
3.) The used HDD should be installed in BEP assy as slave HDD. There are 2 flat cables in the BEP
assy. One is for CDRW drive or MOD and the other is for HDD. The both HDD, used one and new
one should be connected through common flat cable. If the HDD cable is tied by tie wrap, cut the
tie off carefully. The extra connector of HDD cable should be connected to the used HDD as Figure
8-164.
8 - 148
7
Figure 8-163 HDD Mode Setting Jumper
Figure 8-164 Connector HDD Cable
Section 8-8 - PC Block
LOGIQ™ 5 PRO S
ERVICE
M
ANUAL