Skew Adjustment; Streaks In The Sub Scan Direction - Ricoh G176 Service Manual

4.3.3 SKEW ADJUSTMENT

Follow the instructions in this flowchart to correct image skew.

4.3.4 STREAKS IN THE SUB SCAN DIRECTION

If you see streaks or lines at a regular interval in the sub scan direction:
1. Measure the width of the interval between the streaks.
2. Identify the component in the table below that is causing the problem (based on the
size of the measured interval), then inspect that component.
Interval Width (approx.)
94 mm
50 mm
105 mm
100 mm
SM
Check:
OPC Drum (diameter 30 mm)
Transfer Roller (diameter 16 mm)
Fusing Roller (diameter 33 mm)
Pressure Roller(diameter 32 mm)
4-29
General Troubleshooting
G176/G177/G176L